qmk_firmware/keyboards/4pplet/eagle_viper_rep/rev_b
2024-05-03 15:21:29 +10:00
..
keymaps 4pplet Eagle Viper REP Rev B Community Layout Support (#20921) 2023-05-13 06:32:16 -07:00
config.h Data-Driven Keyboard Conversions: 0-9 (#23357) 2024-03-30 13:51:57 +00:00
halconf.h Adding Duck Viper/Eagle V2/V3 Replacement PCB Rev B (#18584) 2022-12-19 20:59:48 +11:00
keyboard.json Data-Driven Keyboard Conversions: 0-9 (#23357) 2024-03-30 13:51:57 +00:00
matrix_diagram.md 4pplet Eagle Viper REP Rev B Community Layout Support (#20921) 2023-05-13 06:32:16 -07:00
mcuconf.h Adding Duck Viper/Eagle V2/V3 Replacement PCB Rev B (#18584) 2022-12-19 20:59:48 +11:00
readme.md Adding Duck Viper/Eagle V2/V3 Replacement PCB Rev B (#18584) 2022-12-19 20:59:48 +11:00
rev_b.c Update GPIO API usage in keyboard code (#23361) 2024-05-03 15:21:29 +10:00
rev_b.h Move single LAYOUTs to data driven (#20365) 2023-04-12 13:42:51 +10:00
rules.mk Data-Driven Keyboard Conversions: 0-9 (#23357) 2024-03-30 13:51:57 +00:00

Viper/Eagle REP Rev B

A alternative PCB for Viper and Eagle V2 and V3

  • Keyboard Maintainer: 4pplet
  • Hardware Supported: Viper/Eagle REP Rev B

Make example for this keyboard (after setting up your build environment):

make 4pplet/eagle_viper_rep/rev_b:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

How to enter bootloader (DFU):

  • Press and hold the button on the keyboard (the small one on the same side as the MCU) for more than 1 second. The keyboard will then enter bootloader (DFU) mode and it's ready to flash the firmware.

  • Note: If holding the button a shorter time, the keyboard will just reset. If you want to exit bootloader mode without flashing a firmware, dissconnect the keyboard from your PC and reconnect it.

Alternative option if the firmware is already pre-flashed:

  • Unplug your keyboard, hold down the Esc-key and at the same time, plug in your keyboard and wait a second before releasing the keys. Bootmagic lite is enabled by default.