qmk_firmware/keyboards/converter/ibm_5291
Joel Challis f5a38b95c1
Remove legacy print backward compatiblitly (#11805)
* Remove legacy print backward compatiblitly

* Remove legacy print backward compatiblitly - core

* revert comment changes
2021-02-06 16:56:13 +00:00
..
keymaps Keyboard: 5291 firmware to replace the existing soarers controller firmware (#4483) 2018-11-26 09:53:49 -08:00
.noci Exclude more keyboards from CI (#11436) 2021-01-13 08:12:28 -08:00
config.h Merge remote-tracking branch 'upstream/master' into develop 2021-01-15 18:34:12 +11:00
ibm_5291.c Keyboard: 5291 firmware to replace the existing soarers controller firmware (#4483) 2018-11-26 09:53:49 -08:00
ibm_5291.h Keyboard: 5291 firmware to replace the existing soarers controller firmware (#4483) 2018-11-26 09:53:49 -08:00
info.json converter/ibm_5291: Configurator support and readme cleanup (#4654) 2018-12-14 22:58:30 -08:00
matrix.c Remove legacy print backward compatiblitly (#11805) 2021-02-06 16:56:13 +00:00
matrix.csv Keyboard: 5291 firmware to replace the existing soarers controller firmware (#4483) 2018-11-26 09:53:49 -08:00
readme.md converter/ibm_5291: Configurator support and readme cleanup (#4654) 2018-12-14 22:58:30 -08:00
rules.mk Trim firmware sizes from default rules.mk, part 1 (#8027) 2020-01-29 12:51:25 -05:00

IBM 5291 keyboard converter

IBM 5291

A converter for the eponymous keyboard.

Keyboard Maintainer: Listofoptions
Hardware Supported: IBM 5291, Teensy 2.0

Make example for this keyboard (after setting up your build environment):

make converter/ibm_5291:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

The pinout is as follows:

IBM5291Cable to Pinhead14

pin description
1 GND
2 NC
3 GND
4 GN)
5 +5V
6 D0
7 D1
8 D2
9 D3
10 D4
11 D5
12 D6
13 Strobe
14 Out

The pins on this connector are organized
here

IBM52912 Cable with DB15M connector

pin description
1,2,3 GND
4 +5V
5 D0
6 D1
7 D2
8 D3
9 D4
10 D5
11 D6
12 Strobe
13 Out
14 PE
15 NC

The above connector is actually numbered so it should be easier to determine where the needed connections are.

To connect to the teensy, the following are pins are needed (if you should choose not set your own):

  • PB0 -> PB6 are connected to D0 -> D6
  • +5V is connected to the corresponding teensy pin
  • gnd is as well, only one of the gnd pins needs to be connected though.
  • strobe is connected to pin PD1
  • data is connected to PD0
  • PE does not need to be connected to anything, but it could also be connected to gnd

sources: http://www.retrocomputing.eu/documents/5291_MaintenanceLibrary.pdf