qmk_firmware/keyboards/handwired/snatchpad
2022-08-06 23:23:35 +10:00
..
keymaps/default [Keyboard] Add Snatchpad keyboard (#16330) 2022-02-21 00:40:11 -08:00
config.h Remove UNUSED_PINS (#17931) 2022-08-06 23:23:35 +10:00
info.json Move keyboard USB IDs and strings to data driven: handwired (#17822) 2022-07-30 17:31:44 +10:00
readme.md [Keyboard] Add Snatchpad keyboard (#16330) 2022-02-21 00:40:11 -08:00
rules.mk [Keyboard] Add Snatchpad keyboard (#16330) 2022-02-21 00:40:11 -08:00
snatchpad.c [Keyboard] Add Snatchpad keyboard (#16330) 2022-02-21 00:40:11 -08:00
snatchpad.h [Keyboard] Add Snatchpad keyboard (#16330) 2022-02-21 00:40:11 -08:00

snatchpad

snatchpad etch-a-sketch macropad

A 6-key macropad with 2 rotary encoders intended for use as a pointing device.

In addition to the 3d printed parts and microcontroller, the following hardware is required:

  • 4 * 3x3 mm threaded inserts
  • 4 * 4mm M3 bolt
  • USB daughter board

  • Keyboard Maintainer: xia0
  • Hardware Supported: e.g. Arduino Pro Micro
  • Hardware Availability: github

Make example for this keyboard (after setting up your build environment):

make handwired/snatchpad:default

Flashing example for this keyboard:

make handwired/snatchpad:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
  • Keycode in layout: Press the key mapped to RESET if it is available