qmk_firmware/keyboards/adafruit/macropad
Ryan 7e0299117b
Move encoder config to data driven (#19923)
Co-authored-by: Nick Brassel <nick@tzarc.org>
2023-02-26 09:45:12 +11:00
..
keymaps Adafruit Macropad: Add VIA keymap, fix default km (#17735) 2022-07-21 14:44:12 +01:00
lib Use a macro to compute the size of arrays at compile time (#18044) 2022-08-30 10:20:04 +02:00
config.h Move encoder config to data driven (#19923) 2023-02-26 09:45:12 +11:00
halconf.h Add Adafruit Macropad (#17512) 2022-07-08 23:33:03 +01:00
info.json Move encoder config to data driven (#19923) 2023-02-26 09:45:12 +11:00
macropad.c Move layouts for direct_pins boards to data driven (#19872) 2023-02-19 18:55:12 +11:00
mcuconf.h Add Adafruit Macropad (#17512) 2022-07-08 23:33:03 +01:00
readme.md [Keyboard] adafruit/macropad: Fix typo (#18616) 2022-10-05 15:37:22 -07:00
rules.mk Migrate MCU and BOOTLOADER to data-driven (#19529) 2023-02-08 18:41:46 +11:00

Adafruit MacroPad RP2040

AdafruitMacropad

A RP2040-powered Macropad with a 3x4 layout.

Make example for this board (after setting up your build environment):

qmk compile -kb adafruit/macropad -km default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Features

  • Raspberry Pi RP2040 Chip + 8MB Flash memory - Dual-core Cortex M0+ at ~130MHz with 264KB of RAM.
  • 3x4 Mechanical key switch sockets - accepts any Cherry MX-compatible switches. Individually tied to GPIO pins (not matrix wired)
  • One NeoPixel RGB LED per switch, on north side.
  • Rotary encoder, 20 detents per rotation, with push-switch on GPIO pin. Push switch is also used for entering bootloader mode when held down on power-up or reset.
  • 128x64 SH1106 Monochrome OLED display - On high-speed hardware SPI port for quick updates.
  • 8mm Speaker/Buzzer - With Class D amplifier and RC filter, can be used to make simple beeps and sounds effects. (Unsupported for now)
  • STEMMA QT Connector - Allows adding any I2C sensors/displays/devices with plug-and-play cables.
  • Reset button - On the side, for quick restarting, press it twice to enter bootloader.
  • Four M3 mounting bosses - Make custom enclosures easily.

Bootloader

Enter the bootloader in 4 ways:

  • Bootmagic reset: Hold down the key just below the rotary encoder push-button on power-up.
  • Physical reset button: Press twice the button on the side while the board is connected.
  • BOOT button Hold down the rotary encoder push-button on power-up or reset.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available.