qmk_firmware/keyboards/tkw/grandiceps
2023-09-14 20:50:07 +01:00
..
keymaps/default Remove legacy keycodes, part 6 (#18740) 2022-10-16 14:14:40 +01:00
rev1
rev2 Migrate i2c EEPROM_DRIVER to info.json (#22013) 2023-09-14 20:50:07 +01:00
config.h Move RGBLight animations to data driven (#21635) 2023-08-23 22:11:39 +01:00
halconf.h
info.json Move RGBLight animations to data driven (#21635) 2023-08-23 22:11:39 +01:00
mcuconf.h
readme.md
rules.mk OLED: driver naming cleanups (#21710) 2023-08-15 10:30:34 +01:00

grandiceps

grandiceps

ARM split keyboard with RGB underglow and encoders.

  • Keyboard Maintainer: vattern
  • Hardware Supported: f411 blackpill
  • Hardware Availability: grandiceps

There are two versions of the Grandiceps. Please use the appropriate firmware for your board.

  • Revision 2 has I2C eeprom and support for a Pimoroni trackball.

Make example for this keyboard (after setting up your build environment):

make tkw/grandiceps:default
make tkw/grandiceps/rev2:default

Flashing example for this keyboard:

make tkw/grandiceps:default:flash
make tkw/grandiceps/rev2:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset buttons: Hold down the BOOT0 button and then briefly press the NRST button on the BlackPill PCB.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available