qmk_firmware/keyboards/adafruit/macropad
2024-04-12 23:34:44 +01:00
..
keymaps Remove userspace keymaps (#22544) 2023-11-27 05:36:45 +11:00
config.h [Audio] Add support for audio shutdown pin (#22731) 2024-03-06 22:02:37 +11:00
halconf.h [Keyboard] Add audio support to Adafruit MacroPad RP2040 (#20353) 2023-04-08 10:59:13 +10:00
keyboard.json Migrate build target markers to keyboard.json - 0AB (#23488) 2024-04-12 23:34:44 +01:00
mcuconf.h [Keyboard] Add audio support to Adafruit MacroPad RP2040 (#20353) 2023-04-08 10:59:13 +10:00
readme.md [Keyboard] adafruit/macropad: Fix typo (#18616) 2022-10-05 15:37:22 -07:00
rules.mk Data-Driven Keyboard Conversions: A (#23379) 2024-04-02 17:45:44 +01:00

Adafruit MacroPad RP2040

AdafruitMacropad

A RP2040-powered Macropad with a 3x4 layout.

Make example for this board (after setting up your build environment):

qmk compile -kb adafruit/macropad -km default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Features

  • Raspberry Pi RP2040 Chip + 8MB Flash memory - Dual-core Cortex M0+ at ~130MHz with 264KB of RAM.
  • 3x4 Mechanical key switch sockets - accepts any Cherry MX-compatible switches. Individually tied to GPIO pins (not matrix wired)
  • One NeoPixel RGB LED per switch, on north side.
  • Rotary encoder, 20 detents per rotation, with push-switch on GPIO pin. Push switch is also used for entering bootloader mode when held down on power-up or reset.
  • 128x64 SH1106 Monochrome OLED display - On high-speed hardware SPI port for quick updates.
  • 8mm Speaker/Buzzer - With Class D amplifier and RC filter, can be used to make simple beeps and sounds effects. (Unsupported for now)
  • STEMMA QT Connector - Allows adding any I2C sensors/displays/devices with plug-and-play cables.
  • Reset button - On the side, for quick restarting, press it twice to enter bootloader.
  • Four M3 mounting bosses - Make custom enclosures easily.

Bootloader

Enter the bootloader in 4 ways:

  • Bootmagic reset: Hold down the key just below the rotary encoder push-button on power-up.
  • Physical reset button: Press twice the button on the side while the board is connected.
  • BOOT button Hold down the rotary encoder push-button on power-up or reset.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available.