qmk_firmware/keyboards/handwired/3dortho14u/rev2
2022-03-19 11:52:40 +00:00
..
config.h [Keyboard] Add keyboard 3dortho14u (#16329) 2022-02-21 11:22:25 -08:00
info.json device_ver -> device_version for some more boards (#16685) 2022-03-19 11:52:40 +00:00
readme.md [Keyboard] Add keyboard 3dortho14u (#16329) 2022-02-21 11:22:25 -08:00
rev2.c [Keyboard] Add keyboard 3dortho14u (#16329) 2022-02-21 11:22:25 -08:00
rev2.h [Keyboard] Add keyboard 3dortho14u (#16329) 2022-02-21 11:22:25 -08:00
rules.mk [Keyboard] Add keyboard 3dortho14u (#16329) 2022-02-21 11:22:25 -08:00

3dortho14u

3dortho14u

A symmetrical 14u wide ortholinear keyboard.

In addition to the 3d printed parts and microcontroller, the following hardware is required:

  • 8 * 12 mm M3 bolt
  • Either:
    • 8 * M3 muts and CA glue OR
    • 8 * 3x3 mm threaded insert
  • Optional:
    • USB daughter board

  • Keyboard Maintainer: xia0
  • Hardware Supported:
    • Arduino Pro Micro (ATmega32u4)
  • Hardware Availability: github

Make example for this keyboard (after setting up your build environment):

make 3dortho14u/rev2:default

Flashing example for this keyboard:

make 3dortho14u/rev2:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
  • Keycode in layout: Press the key mapped to RESET if it is available