qmk_firmware/keyboards/converter/xmk
2023-05-04 19:09:59 +10:00
..
keymaps/default [Keyboard] Add converter/xmk (#18433) 2022-12-19 20:52:03 +11:00
config.h [Keyboard] Add converter/xmk (#18433) 2022-12-19 20:52:03 +11:00
info.json Even more info.json whitespace cleanups (#20703) 2023-05-04 19:09:59 +10:00
post_rules.mk [Keyboard] Add converter/xmk (#18433) 2022-12-19 20:52:03 +11:00
readme.md [Keyboard] Add converter/xmk (#18433) 2022-12-19 20:52:03 +11:00
rules.mk [Keyboard] Add converter/xmk (#18433) 2022-12-19 20:52:03 +11:00
xmk.c Clean up usage of QMK_KEYBOARD_H (#20167) 2023-03-20 08:12:05 +11:00
xmk_matrix.c Clean up usage of QMK_KEYBOARD_H (#20167) 2023-03-20 08:12:05 +11:00
xmk_matrix.h Clean up usage of QMK_KEYBOARD_H (#20167) 2023-03-20 08:12:05 +11:00
xmk_shell.c [Keyboard] Add converter/xmk (#18433) 2022-12-19 20:52:03 +11:00

converter/xmk

converter/xmk is the QMK keyboard definition for 𝑥MK.

  • Keyboard Maintainer: Manna Harbour
  • Hardware Supported: Any QMK-compatible MCU board
  • Hardware Availability: No additional hardware required

Make example for this keyboard (after setting up your build environment):

make converter/xmk:default

Flashing example for this keyboard:

make converter/xmk:default:flash

To flash pre-compiled firmware to a pro-micro on Linux without using the qmk CLI:

avrdude -p atmega32u4 -c avr109 -U flash:w:converter_xmk_default.hex:i -P /dev/ttyACM0

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 4 ways:

  • Boot shell command: Give the boot command to the converter/xmk shell, e.g. echo "boot" > /dev/ttyACM0
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available
  • Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard